The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 19th, 2024, 5:39am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › PSRR simulation set-up of Bandgap Reference in Cadence
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
PSRR simulation set-up of Bandgap Reference in Cadence (Read 3712 times)
analog_design
Junior Member
**
Offline



Posts: 23
INDIA
PSRR simulation set-up of Bandgap Reference in Cadence
Apr 10th, 2012, 5:24am  
Hi Folks,


I am trying to run PSRR simulation on Bandgap. I have design first order bandgap reference and I am facing difficulty while doing simulation of it.

Please, let me know How should I do set-up of PSRR Simulation in Cadence Spectre .

I would be thankful to you.

Thank you  :)
Back to top
 
 
Warm Regards
View Profile analog_design   IP Logged
Horror Vacui
Senior Member
****
Offline



Posts: 127
Dresden, Germany
Re: PSRR simulation set-up of Bandgap Reference in Cadence
Reply #1 - May 25th, 2012, 6:50am  
What is your exciting signal (input) in this case?
What is your output signal in this case?

If you know these than it is straightforward to simulate it.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.