The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 19th, 2024, 4:29pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Galaxy Custom Designer question
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Galaxy Custom Designer question (Read 1841 times)
Analog_Designer
New Member
*
Offline



Posts: 9
Egypt
Galaxy Custom Designer question
May 28th, 2012, 11:14am  
how to plot mosfet Capacitance in Synopsys Custom Designer sweeping vgs  ? as i want to plot Gm/Id Curves ???


Please i need some tutorials about using custom designer .... thanks in advance ....
Back to top
 
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: Galaxy Custom Designer question
Reply #1 - May 29th, 2012, 9:09am  
Did you ask your support representative from Synopsys?

Did you have a look around SolvNet?
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.