The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 13th, 2024, 3:23pm
Pages: 1
Send Topic Print
onchip/offchip decoupling cap (Read 2530 times)
mixed_signal
Senior Member
****
Offline



Posts: 183

onchip/offchip decoupling cap
Aug 08th, 2012, 12:07am
 
The frequency of my circuit is 30khz.  Analog & digital has seperate Vdds but no seperate ground pins.Analog section has onchip decoupling cap of 15pf but digital has no decap.

Is offchip decoupling cap for analog and digital ok?
Back to top
 
 
View Profile   IP Logged
raja.cedt
Senior Fellow
******
Offline



Posts: 1516
Germany
Re: onchip/offchip decoupling cap
Reply #1 - Aug 8th, 2012, 1:14am
 
always on-chip decap is real decap, when you don't have on chip decap only off chip decap one and only the option. Mainly when you have decap off chip it is not cap, you have bond wire in series with  cap which results in a series resonance ckt.

Imagine there is a frequency component at the resonance frequency, but inductor cancels the capacitance.  

Thnak,s
Raj.
Back to top
 
 
View Profile WWW raja.sekhar86   IP Logged
BackerShu
Community Member
***
Offline



Posts: 64

Re: onchip/offchip decoupling cap
Reply #2 - Aug 28th, 2012, 8:46pm
 
raja.cedt wrote on Aug 8th, 2012, 1:14am:
always on-chip decap is real decap, when you don't have on chip decap only off chip decap one and only the option.


Hi Raja,
A little confusion about the last half of quoted part.
Do you mean only one, either analog or digital, should be chosen to be decoupled off chip? If so, what's the reason?

I thought both of them could be decoupled off chip, although it won't be as effective as on chip decoupling.

Back to top
 
 
View Profile WWW   IP Logged
aaron_do
Senior Fellow
******
Offline



Posts: 1398

Re: onchip/offchip decoupling cap
Reply #3 - Aug 29th, 2012, 2:44am
 
Quote:
Hi Raja,
A little confusion about the last half of quoted part.


that's putting it lightly. Also, I don't think that's what he meant.

BTW, why not just assume some 1-2nH bonding wires, and simulate the circuit? See if there is any instability, performance degradation, or noise spikes. If your circuit has any possiblity of fast transients coulping to the power supply, then some on-chip decoupling would help.


regards,
Aaron
Back to top
 
 

there is no energy in matter other than that received from the environment - Nikola Tesla
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.