The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 1:35am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › RF Design › Low power transceiver
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Low power transceiver (Read 1652 times)
mixed_signal
Senior Member
****
Offline



Posts: 183
Low power transceiver
Sep 19th, 2012, 8:40am  
Hi,
I am working on a low power transceiver for Wireless Body area network protocol. How do I get the phase noise specs of my PLL from the protocol specs. The protocol specifies the transmitter specs like EIRP, transmit mask etc. and receiver specs like sensitivity , ACPR etc.
Back to top
 
 
View Profile   IP Logged
loose-electron
Senior Fellow
******
Offline

Best Design Tool =
Capable Designers

Posts: 1638
San Diego California
Re: Low power transceiver
Reply #1 - Sep 22nd, 2012, 12:17pm  
you are using this for up convert mixing correct?

Phase noise of the mix product converts to spectral spreading of the output.
Back to top
 
 
Jerry Twomey
www.effectiveelectrons.com
Read My Electronic Design Column Here
Contract IC-PCB-System Design - Analog, Mixed Signal, RF & Medical
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.