Hi,

1. I am using IC6.1.6-64b.500.1 and my simulator version is 10.1.1.296.isr18 64 bit

2. I am simulating a basic downconversion mixer as shown in attached figure. I want to know the correlation between noise at RF (red) and noise at IF (blue). I tried to follow the following article:
https://www.cadence.com/rl/Resources...rs/tdnoise.pdf

In page 7, it uses noisetype=correlations. But this option is not available in this version. How shall I find my required correlation.

I shall highly appreciate if some provides me an appnote or the steps.