Designer’s Guide Community

‹ Previous topic | Next topic ›

Pages: 1

Error in staircase expression plot in ADE (Read 2997 times)

AMS_ei

Community Member

Offline

Posts: 67

Error in staircase expression plot in ADE
Sep 01^st, 2016, 4:01am

Hi, I am trying to plot a staircase waveform from Calculator in ADE.
I have used the following function to generate the staircase waveform.

(((4 * VT("/oB<2>")) / 5 )+ ((2 * VT("/oB<1>")) / 5) + ((1 * VT("/oB<0>")) / 5))
as shown in the attached waveform. But, I am not getting the staircase waveform.

Could anyone please guide me here?

Thank you.

Warm regards,

adc_output_2.png

IP Logged

Geoffrey_Coram Senior Fellow Offline Posts: 1999 Massachusetts, USA	Re: Error in staircase expression plot in ADE Reply #1 - Sep 2^nd, 2016, 11:26am It looks like you're getting all the transition points right, but then the plot does a linear interpolation between them. Can you just add up scaled copies of your net, without using the VT function?
Back to top	If at first you do succeed, STOP, raise your standards, and stop wasting your time. IP Logged

AMS_ei Community Member Offline Posts: 67	Re: Error in staircase expression plot in ADE Reply #2 - Sep 2^nd, 2016, 11:35pm It is shouting with error. Hence, not able to plot waveform
Back to top	IP Logged

AMS_ei Community Member Offline Posts: 67	Re: Error in staircase expression plot in ADE Reply #3 - Sep 3^rd, 2016, 3:13am It has been resolved.
Back to top	IP Logged

Geoffrey_Coram Senior Fellow Offline Posts: 1999 Massachusetts, USA	Re: Error in staircase expression plot in ADE Reply #4 - Sep 6^th, 2016, 5:50am Perhaps you could post the resolution for the benefit of later visitors to the forum.
Back to top	If at first you do succeed, STOP, raise your standards, and stop wasting your time. IP Logged

Pages: 1

‹ Previous topic | Next topic ›