The Designer's Guide Community
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 24th, 2019, 8:40am
Pages: 1
Send Topic Print
$debug does not work (Read 1059 times)
New Member

Posts: 7

$debug does not work
Sep 29th, 2017, 10:41am
I am trying to print the internal variables defined in my Verilog A model by $debug or $strobe. It works pretty well with MMSIM 121, but when I switch to MMSIM 151, it no longer prints those information. Any thought on this will be helpful.

Back to top
View Profile   IP Logged
Senior Fellow

Posts: 1971
Massachusetts, USA
Re: $debug does not work
Reply #1 - Oct 2nd, 2017, 6:13am
Do you have (* compact_module *) or any other special attributes in the Verilog-A code?
Back to top

If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2019 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to Consider submitting a paper or model.