The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Oct 13th, 2019, 8:18pm
Pages: 1
Send Topic Print
damaging input power vs frequency (Read 498 times)
micanis
New Member
*
Offline



Posts: 1

damaging input power vs frequency
Feb 25th, 2018, 7:20am
 
hello. RF wave might damage electronic component only if it has frequency within the BW of this component?
for example: SAW filter 900MHz, BW=2MHz, maximal RF input = 10dBm. if i apply on it RF signal 800MHz P=33dBm, would the SAW filter be damaged?
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2019 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.