The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 27th, 2024, 2:47am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › RF Simulators › How to find the noisy current in PNOISE
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How to find the noisy current in PNOISE (Read 2028 times)
Aigneryu
Senior Member
****
Offline



Posts: 102
How to find the noisy current in PNOISE
Dec 23rd, 2003, 2:01am  

In PNOISE setup window, there are two options to calulate the output noise: probe and voltage. How can I find a noise current with these two options? If I want to find the noise current in a branch which may be simply composed of a resistor?

Should I use probe??
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.