The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 26th, 2024, 11:37pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › RF Simulators › VCO + DIVIDER using PSS
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
VCO + DIVIDER using PSS (Read 3392 times)
City
Junior Member
**
Offline



Posts: 19
VCO + DIVIDER using PSS
May 25th, 2004, 5:32am  
hello,

Is there any special setting in the PSS analysis of a VCO + DIVIDER or shall we simply set pss fund = output freq of the divider ? Shall we specifiy anything additional for the oscillator ?

Thanks,

CIty
Back to top
 
 
View Profile   IP Logged
Ken Kundert
Global Moderator
*****
Offline



Posts: 2384
Silicon Valley
Re: VCO + DIVIDER using PSS
Reply #1 - May 25th, 2004, 9:10am  
You should specify the estimated period as being that of the divider, and you should specify an observation point at the output of the divider.

-Ken
Back to top
 
 
View Profile WWW   IP Logged
City
Junior Member
**
Offline



Posts: 19
Re: VCO + DIVIDER using PSS
Reply #2 - May 27th, 2004, 12:26am  
Ken,

thank you that works well.

City
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.