The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 17th, 2024, 1:54am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Analog Design › How to compensate the offset of CMFB amplifier?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How to compensate the offset of CMFB amplifier? (Read 401 times)
Analoger
Junior Member
**
Offline



Posts: 15
How to compensate the offset of CMFB amplifier?
Nov 13th, 2005, 3:11pm  
Could anyone advise usually how people compensate the offset of the CMFB amplifer?  ???
Back to top
 
 
View Profile   IP Logged
Analoger
Junior Member
**
Offline



Posts: 15
Re: How to compensate the offset of CMFB amplifier
Reply #1 - Nov 18th, 2005, 10:27pm  
Do people use the same techniques such as autozeroing or chopper stabilization to compensate the offset in  the CMFB amplifiers?
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.