Designer’s Guide Community

jcpu2006

Junior Member

Offline

Posts: 19
Hsinchu

Including SPICE netlist
Feb 13^th, 2006, 9:48pm

Hi, I am analog guy following Composor --> Virtuosso --> Calibre flow.
From time to time, I end up with some SPICE netlists
which I would really like to put back somewhere into my original Composor scheme.
Maybe as a certain "??? view" in a cell where I can generate a "Symbol View" for it,
so that I can integrate this part of circuit latter under Composor scheme by just drawing its symbol
instead of manually inclusion of the SPICE netlist after each CDL OUT NETLIST.

Thanks in advance.

Back to top

IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: Including SPICE netlist Reply #1 - Feb 13^th, 2006, 10:42pm If it's for CDL netlisting, you can do that. It's covered in http://sourcelink.cadence.com solutions - numbers 11164856 and 11164862 (depending on which netlister you're using). Bit pushed for time at the moment, otherwise I'd give the full details here. Andrew.
Back to top	IP Logged

Paul

Community Fellow

Offline

Posts: 351
Switzerland

Re: Including SPICE netlist
Reply #2 - Feb 14^th, 2006, 1:30pm

Hi,

it is not clear whether you are talking about including a CDL netlist or about Calibre PEX extraction, which you want to generate a schematic from for post-layout simulation. In the first case, please follow Andrew's instructions. In the latter case, you find an appnote here:
http://www.mentor.com/supportnet/member/appnotes/pdf/0336.pdf

Paul

Back to top

IP Logged

jcpu2006 Junior Member Offline Posts: 19 Hsinchu	Re: Including SPICE netlist Reply #3 - Feb 17^th, 2006, 5:59pm Dear Paul: It should be the first case. And it's general, for another example, we now do PLL with divider and it's control by verilog. Digital designers outcome is working netlist in SPICE format. Which is acceptable. But my top cell is drawn by composor. So I need to include the divider netlist for all purpose. Thanks,
Back to top	IP Logged