nijMcnij
New Member
Offline
Posts: 1
|
hello all,
i have modelled a 10 bit charge redistribution SAR ADC in verilog A, the thing works fine.....but until now i have only been checking the output values using the waveform editor......i would like to use the fstrobe function to record the digital outputs to a file for later analysis.
but here is the catch, the digital outputs are either 3.3V (for a digital 1) or a 0 for a digital 0......how to do use the fstrobe function to record a value of 1 for a 3.3V and a 0 for a 0.....i tried the %B formating code but i get a compilation error "not supported yet"....i am using spectre
many thanks for your assistance
|