Cri Azzolini
Community Member
Offline
Posts: 48
University of Parma, Italy
|
Hi all,
I recently perfomed mixed-mode simulation of a design containing both analog (schematic) and digital (verilog) section with AMS-Designer. I noted that the same transient simulation performed on a schematic containing only the analog section of the design takes more time with Spectre: the difference is huge, about 50% or maybe more! The simulation is run on the same workstation and the simulation queue was empty in both cases.
I cannot explain how this may happen: I mean, as far as I know, AMSDesigner uses Spectre for the simulation of the analog part of the circuit! Any ideas?
Thanks, Cri
|