The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 7th, 2024, 8:47pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design Languages › Verilog-AMS › IS there any training class or doc on Verilog-AMS?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
IS there any training class or doc on Verilog-AMS? (Read 2037 times)
neoflash
Community Fellow
*****
Offline

Mixed-Signal
Designer

Posts: 397
IS there any training class or doc on Verilog-AMS?
Nov 03rd, 2006, 7:27pm  
I would like to lean it, howeverm found it is hard to kick off.
Back to top
 
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1998
Massachusetts, USA
Re: IS there any training class or doc on Verilog-
Reply #1 - Nov 6th, 2006, 6:08am  
Some EDA vendors have training classes.  Also consider the book:

http://www.designers-guide.org/Books/#Kundert-2004
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.