The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 17th, 2024, 5:22pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › RF Design › Which Bits in Bluetooth EDR Mode Determing 2M or 3
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Which Bits in Bluetooth EDR Mode Determing 2M or 3 (Read 1814 times)
qiushidaren
Community Member
***
Offline

I am a lovely
MOSFET!

Posts: 86
Chengdu
Which Bits in Bluetooth EDR Mode Determing 2M or 3
Aug 13th, 2007, 11:59pm  
Hi all,

In Bluetooth EDR mode where are the control bits which control whether the data rate is 2M or 3M?

Best regards,
Terry
Back to top
 
 
View Profile WWW   IP Logged
didac
Senior Member
****
Offline

There's a million
ways to see the
things in life

Posts: 247
manresa,spain
Re: Which Bits in Bluetooth EDR Mode Determing 2M
Reply #1 - Aug 14th, 2007, 6:27am  
Hi Terry,
I haven't worked with Bluetooth for a while but if you look at the specs in page 40 it tells you wich bits of LMP indicate each mode, also in page 390 you have the mask of the LMP PDU.
Hope it helps,
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.