Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Jul 18^th, 2024, 9:21am

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Design › Analog Design › how to use cmdmprobe in stb analysis

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

how to use cmdmprobe in stb analysis (Read 857 times)

Julian18 Community Member Offline Posts: 55	how to use cmdmprobe in stb analysis Feb 26^th, 2008, 4:40am hi, there. i want to analysis the stability of this full differential OTA(shown below), how to add the cmdmprobe into this circuit to do the stb analysis? Thanks.
Back to top	1_003.JPG IP Logged

James Bond Community Member Offline Posts: 82	Re: how to use cmdmprobe in stb analysis Reply #1 - Feb 26^th, 2008, 4:45am Hi, I think there is a component in the analoglib called iprobe, in order to use that , you need to put this component in between your common output from opamp and cmfb input, and run stb analysis. Hope it will help. james
Back to top	IP Logged

Frank Wiedmann Community Fellow Offline Posts: 678 Munich, Germany	Re: how to use cmdmprobe in stb analysis Reply #2 - Feb 26^th, 2008, 4:53am See http://www.designers-guide.org/Forum/YaBB.pl?num=1190707743/1#1. Connect the positive output via the cmdmprobe with the negative input and vice versa.
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.