The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 12:30pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › RF Design › Offset-PLL
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Offset-PLL (Read 2314 times)
Faisal
Community Member
***
Offline



Posts: 90
Offset-PLL
Jun 10th, 2008, 8:15am  
Hi,

I am exploring an Offset-PLL architecture. From the circuit point of view, what are the issues that occur when we put a mixer inside...Any special precautions that one has to do in addition to normal PLL ?

Kind Regards,
Faisal Mateen.
Back to top
 
 
View Profile   IP Logged
buddypoor
Community Fellow
*****
Offline



Posts: 529
Bremen, Germany
Re: Offset-PLL
Reply #1 - Jun 11th, 2008, 6:47am  
Hello Faisal,

perhaps the attached document can be helpful for you; if not - waste it.
Back to top
OFFSETPLL.pdf  
 
LvW (buddypoor: In memory of the great late Buddy Rich)
View Profile   IP Logged
Faisal
Community Member
***
Offline



Posts: 90
Re: Offset-PLL
Reply #2 - Jun 11th, 2008, 12:49pm  
Thanks, its good for a start  :)
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.