The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 20th, 2024, 1:16pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › how to set initial condition in post-extracted netlist in ADE
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
how to set initial condition in post-extracted netlist in ADE (Read 1310 times)
Dipankar
Community Member
***
Offline



Posts: 59
how to set initial condition in post-extracted netlist in ADE
Sep 16th, 2008, 7:34am  
Dear All,

             How can I set initial condition at some node of a post-extracted netlist from ADE?

The rc-extracted file (that I include in model library section) is ***.spf and I use hier-editor to use the spectre view of the top block.

Dipankar.
Back to top
 
 
With Thanks and Regards,
Dipankar.
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.