The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 18th, 2024, 6:13am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › How to plot operating point parameters vs. time in a transient simulation?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How to plot operating point parameters vs. time in a transient simulation? (Read 1626 times)
analogue_guy
Community Member
***
Offline



Posts: 38
How to plot operating point parameters vs. time in a transient simulation?
Apr 20th, 2009, 12:42am  
Hi all,

I was thinking if it is possible to plot operating point parameters of a transistor vs. time in spectre (assuming I am running a transient simulation)?

Thanks

Regards
--AG
Back to top
 
 
View Profile   IP Logged
analogue_guy
Community Member
***
Offline



Posts: 38
Re: How to plot operating point parameters vs. time in a transient simulation?
Reply #1 - Apr 20th, 2009, 2:24am  
Okay, it is possible. I have found a solution using AWD, simple the oppoints should be saved like save M0:oppoint in an additional spectre file.

br

--AG
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.