Hi Guys,
I failed to save and plot node voltage in a post-layout simulation. Last week I ran a post-layout simulation with RC extracted view. That was extracted using Assura. I tried to save and plot a few nodes inside the RC extracted view. I set up the config view, chose the schematic view first. Then select a few nodes in the schematic. Then I switched to RC extracted view in Hierarchy editor and Run simulation. But two nodes in all my selections are not saved. The following is detailed information in ncsim.log.
Quote:ncsim> probe -create -emptyok -database ams_database {adc_sim.I0.u_adc.muxout_m}
Created probe 4
ncsim> probe -create -emptyok -database ams_database {adc_sim.I0.u_adc.muxout_p}
Created probe 5
************************************************
Transient Analysis `tran': time = (0 s -> 50 us)
************************************************
Warning from spectre during IC analysis, during transient analysis `tran'.
adc_sim.I0.u_adc.muxout_m is not present in the design.
adc_sim.I0.u_adc.muxout_p is not present in the design.
Trying `homotopy = gmin' for initial conditions.
Trying `homotopy = source' for initial conditions.
Any comments are appreciated.
Yawei