Designer’s Guide Community

analog_design Junior Member Offline Posts: 23 INDIA	Command o create Netlist in Spectre May 03^rd, 2011, 12:45am Hi, I want to run simulation through command prompt in spectre. Please, let me know what is command to create netlist from schematic circuit. I forgot it and try to look in to user manual but, I didnt find it. Please, explain me how i can run simulation without use of ADE ? You help would be appreciated.
Back to top	Warm Regards IP Logged

sheldon Community Fellow Offline Posts: 751	Re: Command o create Netlist in Spectre Reply #1 - May 3^rd, 2011, 4:50am Analog_design, You will need to use ADE to create the netlist, or create it manually. To create a netlist in ADE, select Simulation --> Netlist --> Create or Recreate. Once you have the netlist you can simulate with Spectre from the command line so you can simulate without ADE. Best Regards, Sheldon
Back to top	IP Logged

boe Community Fellow Offline Posts: 615	Re: Command o create Netlist in Spectre Reply #2 - May 6^th, 2011, 11:40am Analog_design, you can also use ADE to create OCEAN script for netlisting. B O E
Back to top	IP Logged

analog_design Junior Member Offline Posts: 23 INDIA	Re: Command o create Netlist in Spectre Reply #3 - May 8^th, 2011, 9:54pm Thank you very much for your reply. I would like to simulate without use of ADE. i know the command to simulate i.e spectre xxx.scs but, I do not know the procedure to create netlist of circuit. Please, let me know the steps irrespective of use of ADE. your reply would be appreciated. Thank you.
Back to top	Warm Regards IP Logged

sheldon Community Fellow Offline Posts: 751	Re: Command o create Netlist in Spectre Reply #4 - May 9^th, 2011, 3:59am Analog-design, You can simulate without the environment as described, using the spectre command. However, netlisting is not simulation, netlisting is part of the environment. Your options for netlisting are either interactive, ADE, batch mode, OCEAN, or manually creating the netlist. Best Regards, Sheldon
Back to top	IP Logged

boe

Community Fellow

Offline

Posts: 615

Re: Command o create Netlist in Spectre
Reply #5 - May 9^th, 2011, 9:50am

analog_design wrote on May 8^th, 2011, 9:54pm:

Thank you very much for your reply. I would like to simulate without use of ADE. i know the command to simulate i.e spectre xxx.scs �but, I do not know the procedure to create netlist of circuit.

Please, let me know the steps irrespective of use of ADE.

your reply would be appreciated.

Thank you.

As already stated, you could use an OCEAN script (assuming you have your design as a Cadence schematic). I am too busy to write code that I can have generated, so I always use ADE once to create an OCEAN script template for netlisting, which I modify as needed.

B O E

Back to top

IP Logged

analog_design Junior Member Offline Posts: 23 INDIA	Re: Command o create Netlist in Spectre Reply #6 - May 12^th, 2011, 11:35pm Hi All, Thank you very much to all for help and information
Back to top	Warm Regards IP Logged