The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 3:26pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design Languages › Verilog-AMS › annotating a verilog-a(ms) variable onto a symbol in Cadence
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
annotating a verilog-a(ms) variable onto a symbol in Cadence (Read 2451 times)
e102
New Member
*
Offline



Posts: 1
annotating a verilog-a(ms) variable onto a symbol in Cadence
Aug 17th, 2011, 6:34am  
Hi,

I am interested in creating a symbol in Cadence which will have a label on it which is the value of a variable inside the verilog-a code of that block after a simulation has run.

Does anyone know if it is possible to do this?

Many Thanks
Back to top
 
 
View Profile   IP Logged
boe
Community Fellow
*****
Offline



Posts: 615
Re: annotating a verilog-a(ms) variable onto a symbol in Cadence
Reply #1 - Aug 17th, 2011, 12:48pm  
e102,

If you have the labels
 cdsParam(1), cdsParam(2), ...
in your symbol, you can select with CDF parameter
 paramLabelSet
which parameters should be displayed.

B O E
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.