Forum
Forum
Verilog-AMS
Analysis
Modeling
Design
Theory
Welcome, Guest. Please
Login
or
Register.
Please follow the Forum
guidelines
.
Sep 5
th
, 2024, 5:21am
Home
Help
Search
Login
Register
PM to admin
The Designer's Guide Community Forum
›
Design
›
Analog Design
› CMOS Op amp Design procedure
‹
Previous topic
|
Next topic
›
Pages: 1
CMOS Op amp Design procedure (Read 492 times)
GaAs_si
Junior Member
Offline
Posts: 24
sandy
CMOS Op amp Design procedure
Oct 14
th
, 2011, 11:11pm
Hi,
I am looking for a detailed step by step procedure to design an opamp.
Thanks in advance.
Siddhartha.
Back to top
IP Logged
raja.cedt
Senior Fellow
Offline
Posts: 1516
Germany
Re: CMOS Op amp Design procedure
Reply #1 -
Oct 15
th
, 2011, 6:30am
hello,
it is very difficult to explain like this. Better start reading books like razavi, or i would strongly suggest allen holburg (which gives some design steps). Please go through the following video lectures, which are very good to start analog design carrer.
http://www.ee.iitm.ac.in/~nagendra/videolectures/doku.php?do=login
Thanks,
raj.
Back to top
IP Logged
weber8722
Community Member
Offline
Posts: 95
Re: CMOS Op amp Design procedure
Reply #2 -
Nov 17
th
, 2011, 8:05am
Also important, become clear on your goals!! If you think something is not important, then maybe you have no full understanding. And if you overlook something you may have to restart again - good training. Holberg is very good also Ivanow!!
Back to top
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent Posts
» 10 most recent Topics
Design
- RF Design
»» Analog Design
- Mixed-Signal Design
- High-Speed I/O Design
- High-Power Design
- Mixed-Technology Design
Analog Verification
- Analog Functional Verification
- Analog Performance Verification
Measurements
- RF Measurements
- Phase Noise and Jitter Measurements
- Other Measurements
Modeling
- Semiconductor Devices
- Passive Devices
- Behavioral Models
- Transmission Lines and Other Distributed Devices
Design Languages
- Verilog-AMS
- VHDL-AMS
Simulators
- Circuit Simulators
- RF Simulators
- AMS Simulators
- Timing Simulators
- System Simulators
- Logic Simulators
Other CAD Tools
- Entry Tools
- Physical Verification, Extraction and Analysis
- Unmet Needs in Analog CAD
General
- Tech Talk
- News
- Comments and Suggestions
- Opportunities
« Home
‹ Board
The Designer's Guide Community Forum
» Powered by
YaBB 2.2.2
!
YaBB
© 2000-2008. All Rights Reserved.
Copyright 2002-2024
Designer’s Guide Consulting, Inc.
Designer’s Guide
® is a registered trademark of
Designer’s Guide Consulting, Inc.
All rights reserved.
Send comments or questions to
editor@designers-guide.org
. Consider
submitting
a paper or model.