The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 17th, 2024, 9:21pm
Pages: 1
Send Topic Print
Questions about Ken's ideal sample and hold model ? (Read 1938 times)
Jacki
Senior Member
****
Offline



Posts: 237

Questions about Ken's ideal sample and hold model ?
Feb 21st, 2013, 1:00am
 
Hi,

   I am not familiar with verilog A, so it is a little difficult for me to understand and use Ken's ideal sample and hold model in his white paper http://www.designers-guide.org/Analysis/sc-filters.pdf.

   Could anybody explains it a little bit, especially the variables like Pin, Nin, Pout, Nout? What do they mean, and how I should use the model?

   Thank you very much!

   Jacki.
Back to top
 
 
View Profile   IP Logged
Jacki
Senior Member
****
Offline



Posts: 237

Re: Questions about Ken's ideal sample and hold model ?
Reply #1 - Feb 21st, 2013, 1:13am
 
Can I use the ideal switch (from analogLib) as the ideal sample and hold?

   Jacki.
Back to top
 
 
View Profile   IP Logged
Jacki
Senior Member
****
Offline



Posts: 237

Re: Questions about Ken's ideal sample and hold model ?
Reply #2 - Feb 22nd, 2013, 12:28am
 
Hi,

   It is my test bench as shown below, I don't know how to connect the output from switched capacitor circuits to the ideal sample and hold model.

   Any comments?

   Thank you.
Back to top
 

Figure_1.png
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.