The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 16th, 2024, 7:12pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › RF Simulators › RF sim and switching converters
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
RF sim and switching converters (Read 1886 times)
Bob Atwell
New Member
*
Offline



Posts: 9
Tucson, AZ
RF sim and switching converters
Oct 04th, 2013, 2:16pm  
Has anyone ever tried to use an RF simulation (QPSS perhaps) on a switching DC-DC converter?  Does the idea make any sense?  Could you see load regulation effects?

Thanks,  Bob.
Back to top
 
 
View Profile   IP Logged
Frank Wiedmann
Community Fellow
*****
Offline



Posts: 678
Munich, Germany
Re: RF sim and switching converters
Reply #1 - Oct 7th, 2013, 12:43am  
PSS analysis and its associated small-signal analyses are very well suited for DC-DC converters. Please see my comments at http://www.cadence.com/community/blogs/rf/archive/2009/04/22/spectre-rf-by-any-o....
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.