The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 18th, 2024, 2:11pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Measurements › RF Measurements › RF connectors
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
RF connectors (Read 3310 times)
mixed_signal
Senior Member
****
Offline



Posts: 183
RF connectors
Jul 02nd, 2014, 8:14pm  
Hi,

What does 1mm, 2.4mm, 3.5mm RF connector signify? Is it the diameter of the pin in male connector?
Back to top
 
 
View Profile   IP Logged
rfidea
Senior Member
****
Offline



Posts: 159
Europe
Re: RF connectors
Reply #1 - Oct 30th, 2014, 2:04pm  
Close guess, the 3.5mm is the inner diameter of the outer conductor (the shield)
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.