The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 5th, 2024, 1:24pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › STB phase start with 0 degree
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
STB phase start with 0 degree (Read 526 times)
newic
Senior Member
****
Offline



Posts: 138
STB phase start with 0 degree
Aug 14th, 2015, 1:54am  
Hi

I am designing a classical folded cascode classAB opamp. The STB result of the phase looks strange as the phase started with 0 degree instead of 180o in the usual case.

Back to top
snapshot_010.png  
 
snapshot_010.png
View Profile   IP Logged
Frank Wiedmann
Community Fellow
*****
Offline



Posts: 678
Munich, Germany
Re: STB phase start with 0 degree
Reply #1 - Aug 17th, 2015, 4:55am  
You might want to take a look at http://www.designers-guide.org/Forum/YaBB.pl?num=1294178255.
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.