SantoS_Nano
Junior Member
Offline
Posts: 13
|
I am using GaN pHEMT model.
"No DC convergence": I am using Agilent ADS tool for my design. When i was simulating my circuit, sometimes it's showing error message like "NO DC CONVERGENCE" and sometimes it's simulating without errors for the same circuit. so, i have decided that it's not problem with the circuit(topology) and it might be with the tool(selection of simulators, modes). i have tried s many options in that tool. finally I could solve it by changing convergence mode in DC-simulation set up.
As I am trainee and recently entered into this area, i couldn't analyze how it was get solved by changing convergence mode, But temporarily i got solution for this problem.
thank you for your response.
|