Ata Sarrafi
New Member
Offline
Posts: 3
|
Hello guys,
I have been busy with a problem for couple of days. I will be more than grateful if you help me with this.
I am new in RF design and I am trying to simulate a simple LNA with ADS. My problem is, I do not want to match my LNA's output to 50ohm because, it is in the chip and it will be connected to mixer.
My question is, when I put terminal at the output of LNA what should be the Z of terminal. Without output terminal I am not able to observe noise and some other parameters. I can just plot S11 >:(
best,
Ata
|