The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 4th, 2024, 10:28am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Other CAD Tools › Entry Tools › Problems to start LVS in assura3.1.4
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Problems to start LVS in assura3.1.4 (Read 3387 times)
cyrus
New Member
*
Offline



Posts: 2
Problems to start LVS in assura3.1.4
Mar 01st, 2006, 5:36am  
Hello together,

I have the following problem during the LVS check. When I start the LVS I get the following
the message that the LVS failed. The problem is described as follows: Segementation violation
Did someone has this problem ? Is this a bug? Because with assura 3.1.2 the LVS runs.


Greetz
Back to top
 
 
View Profile   IP Logged
Paul
Community Fellow
*****
Offline



Posts: 351
Switzerland
Re: Problems to start LVS in assura3.1.4
Reply #1 - Mar 1st, 2006, 12:50pm  
Cyrus,

you mentioned Assura 3.1.2, but what version are you currently using? What Cadence version are you using, what is your OS (type and release)?
Did you check Sourcelink for possible solved problems?

Paul
Back to top
 
 
View Profile WWW   IP Logged
cyrus
New Member
*
Offline



Posts: 2
Re: Problems to start LVS in assura3.1.4
Reply #2 - Mar 2nd, 2006, 8:58am  
As mentioned in the top line I used assura 3.1.4 that did not run!
The software is installed on a solaris workstation SunOS 5.8. Cadence version is 5.1.41
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.