The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Oct 5th, 2024, 7:21pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Analog Design › Shielding on differential lines
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Shielding on differential lines (Read 1602 times)
fonseca.ha
Junior Member
**
Offline



Posts: 28
UK
Shielding on differential lines
Mar 08th, 2007, 3:53am  
I have an audio sensitive differential signal to route accross the chip, between a driver and a receiver. This line is to be shielded but I have one doubt. Is it better to connect the shield to the ground on the driver side or on the receiver side?

Thank you
Back to top
 
 
View Profile   IP Logged
chase.ng
Community Member
***
Offline



Posts: 77
penang/malaysia
Re: Shielding on differential lines
Reply #1 - Mar 12th, 2007, 8:09pm  
The shielding ground should be connected at the receiver side.
Back to top
 
 
Chase
View Profile chase.ng   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.