The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 16th, 2024, 11:21am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › RF Simulators › A question about the simulation of PA
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
A question about the simulation of PA (Read 2799 times)
calven
Junior Member
**
Offline



Posts: 18
A question about the simulation of PA
Apr 15th, 2007, 9:39pm  
hi!
i am designing a PA for IEEE 8012.11b 11MB/S WLAN applications.i do not know how to simulate its ACPR with spectreRF.Has anyone done this?Please tell me the detailed method.thanks a lot!
Back to top
 
 
View Profile   IP Logged
sigdel_pll
New Member
*
Offline



Posts: 3
Re: A question about the simulation of PA
Reply #1 - Apr 20th, 2007, 12:13pm  
Try cadence "source link", load pull simulation, I remember seeing some example on how to set up acpr simulation
Back to top
 
 
View Profile   IP Logged
vivarf
Community Member
***
Offline



Posts: 35
Re: A question about the simulation of PA
Reply #2 - May 30th, 2007, 9:50pm  
I finally find out this one: http://www.cadence.com/community/virtuoso/resources/SpectreRF_PA533AN.pdf
It is an great example of RF amplifier design, the setup and simulation of Load pull and ACPR are described in detail.
Back to top
 
 
View Profile veeater   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.