The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 2nd, 2024, 12:22am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Spectre doesn't save all signals
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Spectre doesn't save all signals (Read 624 times)
M.C.
New Member
*
Offline



Posts: 3
Spectre doesn't save all signals
Mar 12th, 2008, 12:24pm  
Hi,

I'm simulating a flash ADC, and would like to view the outputs of the different comparators.  However, when I have more than a certain number of blocks, the simulation doesn't save all the signals, even though I specify "save all."  Has anyone faced this before when using Cadence?  

Thanks.
Back to top
 
 
View Profile   IP Logged
haikom
Junior Member
**
Offline



Posts: 17
Germany
Re: Spectre doesn't save all signals
Reply #1 - May 3rd, 2008, 1:39pm  
Hi,

try to increase the subcircuit probe level in the ouput options.

Regards,
hqqh
Back to top
 
 
View Profile haikomo   IP Logged
navywhj
New Member
*
Offline



Posts: 3
China
Re: Spectre doesn't save all signals
Reply #2 - Jun 3rd, 2008, 3:21am  
sorry,i do not meet the thing,you can rerun again
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.