Tlaloc
Community Member
![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif) ![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif)
Offline
Posts: 81
Dallas, TX
|
When I run a PNoise sim with sources and specify an voltage input on a vsource instance, I am able to look at the input referred noise. Then, when I change the sim to tdnoise, the input referred noise is not saved. I made no changes to the schematic nor to any of the settings (other than the frequency range of the pnoise sim). Why is this?
|