santo
New Member
Offline
Posts: 2
|
Hi,
I am a new member to this site, so firstly hello to everyone.
I have a very simple question to start with. (I apologise if this is not in the corrrect area of the forum).
I am creating a replica of the 'ahdlLib' 'd_ff' cell. The only difference is that I am adding an asynchronous reset. I have modified both the veriloga code and the symbol view to have this reset pin. However, everytime I 'check and save' the symbol view in Cadence virtuoso, there is a cross view check warning, stating that the view in the symbol is not found in the veriloga code. The simple testbench I have does not operate due to this warning.
I am pretty sure the verlioga code is correct, so is there some thing else that I could be missing here? Do I need to do any sort of compliation of the symbol ar anything like that?
Thanks in advance to anyone who offers assistance.
Regards
|