The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 18th, 2024, 12:29pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Logic Simulators › how to reverse the signal order when create bus in irun results?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
how to reverse the signal order when create bus in irun results? (Read 71 times)
liletian
Community Member
***
Offline



Posts: 97
MD
how to reverse the signal order when create bus in irun results?
Aug 18th, 2018, 11:45am  
HI all

How to reverse the signal order when you create bus? As you can see from the attachement, the signal order is from 0 to 7, I would like to have the bus from 7 to 0 instead.

Thank you,
Back to top
att.png  
 
att.png
View Profile   IP Logged
deba
Community Member
***
Offline



Posts: 84
Re: how to reverse the signal order when create bus in irun results?
Reply #1 - Aug 20th, 2018, 2:20am  
While creating bus, it depends on the order of selection.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.