Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

May 5^th, 2024, 10:22pm

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Design › Mixed-Signal Design › porblem in running Dracula

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

porblem in running Dracula (Read 5841 times)

jimmy Community Member Offline Posts: 32	porblem in running Dracula Nov 20^th, 2004, 6:20pm I got an error message when I want to debug LVS errors after running Dracula. Can not find BOUNDARY.DAT at /tmp/iqDir/a023352/Dracula/ ! ERROR: No LAYDE.DIS in the input paths ! Please do Setup ! But I do have the LAYDE.DIS file in my running directory. Does anyone have idea of what is the problem? Thank you, jimmy li
Back to top	IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: porblem in running Dracula Reply #1 - Nov 21^st, 2004, 10:17pm Do you have KEEPDATA=YES or KEEPDATA=INQUERY in your *DESCRIPTION block? Are you doing Tools->Dracula Interactive->Setup->LVS? Regards, Andrew.
Back to top	IP Logged

ywguo Community Fellow Offline Posts: 943 Shanghai, PRC	Re: porblem in running Dracula Reply #2 - Nov 22^nd, 2004, 7:54am Jimmy, According my experience, if KEEPDATA=SMART, all the files storing the LVS error message are removed. So you may not run dracula interactive. Pls set to KEEPDATA=INQUERY or KEEPDATA=YES. Good luck! Yawei
Back to top	IP Logged

jimmy Community Member Offline Posts: 32	Re: porblem in running Dracula Reply #3 - Nov 22^nd, 2004, 10:39am Andrew and Yawei, Thank you so much. Now it works after I set KEEPDATA=YES. The default value in our prcess kit is SMART. Thank you again, jimmy li
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.